M65 Pro RGB Side buttons stop working I bought a factory refurb'd M65 PRO RGB from Scan.co.uk less than a week ago, however as described in the title the side thumb buttons cease to work unless i use one of two workarounds. The likely cause is some sort of a problem with the switch to the front panel. Simply, power OFF your computer and also unplug the computer from its power source. The backlight for the power button and reset buttons on the mobo are lit, however these buttons are not working. No Q codes show up on the motherboard either. I liked using CAM software to keep track of more info than Afterburner can and now (I suspect after Win 10 Anniversary update) the software wont even try launching. 2. you might face problems with aura sync when this feature is on.To make sure that, you are facing this problem, you will sometimes see that only the IO shield of the motherboard is blinking with red light. Page 1 of 2 - Case fans not spinning - posted in Internal Hardware: When i am using my computer, my case fans are not spinning at all. It just sends a signal to the power supply to turn on. After waiting for 2 minutes, connect the computer back to its power source and Power it on. Reset Button Not Working. My Razer Kraken headset recently stopped working on my Windows 10 64bit Lenovo Desktop PC. Unplug the big black power cable from the back of the computer. Troubleshooting steps taken: 1. Used Reset CMOS button/Reset button on board 2. Joined Mar 24, 2011 Messages ... Been using power button restart if system freezes. A power button can not damage a power supply. Fast Startup feature of Windows: The Fast Start up feature of Windows 10 let's the PC start very fast but it has some side effects too. Reset CMOS button appears to work "power/reset lights flash". NZXT seems to not be responding to the posts on their help forum so I was wondering if many ppl were having this issue, and if … The problem of USB Ports not working in Windows 10 could be due to the drivers for USB Ports getting corrupted. If you can't find the problem, a call to nzxt will probably result in a replacement switch and wire. Reinstall Faulty Device Drivers. There is not much power in it to begin with. They normally always start … Thread starter DiogoCDS19; Start date Jan 7, 2013; D. DiogoCDS19. Try using the reset switch pair which acts the same as the power pair. The headset works perfectly with other devices, however when I plug it in to my PC, I can't hear anything. Since launching our first product in 2004, NZXT has delivered affordable premium cases that enable gamers to build the extraordinary. If it’s a laptop, remove the battery as well Hold the ‘on’/power button your computer Wait 5 seconds Press the power button to ‘turn off’ your computer Plug in the big black power cable from the back of the computer again Turn on your computer I checked the control panel to see what was wrong and it says that my headset is disconnected, but it is clearly plugged into the computer. Reconnected front panel buttons 3.