Graco SLIMFIT: Instruction Manual | Brand: Graco | Category: Car Seat | Size: 20.01 MB | Pages: 113 . We manufacture equipment to move, measure, mix, control, dispense and spray fluids that are … There’s the forward facing belt-positioning booster mode. This car seat design is really sleek. There are dozens of newer convertible car seats on the market. Page 1 PD349304A 3/16 SLIMFIT Do not install or use this child restraint until you read and understand the instructions in this manual. SlimFit® 3-in-1 Car Seat. Manual Storage — the manual tucks into a compartment on the back of the seat. Securing the Child Graco is one of the world’s leading suppliers of fluid management products and packages. Do not install or use this child restraint until you read and understand the instructions, FAILURE TO PROPERLY USE THIS CHILD RESTRAINT INCREASES THE RISK OF SERIOUS INJURY, All-in-one child restraint system (47 pages), Manual will be automatically added to "My Manuals", Remove Latch Connectors From Storage Location, Place Car Seat Rear-Facing in Back Seat of the Vehicle, Connect Latch Connectors to Vehicle’s Lower Latch Anchors, Install Rear-Facing with Vehicle Seat Belt, Vehicle Lap/Shoulder Seat Belt with Top Tether Strap, Vehicle Lap Only Seat Belt Withtop Tether Strap, Remove Latch Connectors and Top Tether Straps From Storage Locations, Place Car Seat Forward-Facing in Back Seat of the Vehicle, Install Forward-Facing with Vehicle Seat Belt, Unhook Top Tether Strap From Storage Location and Lay It in the Seat, Place the Booster Seat Forward-Facing in the Back Seat of Vehicle, Make Sure Latch Strap Is in the Forward-Facing Belt Path, Marked with Orange Label, Thread the Vehicle Shoulder Belt Through Shoulder Belt Guide On the Headrest, Place Harness Straps Over Child’s Shoulders and Buckle, Be Sure the Harness Straps Are at the Proper Height, To Raise or Lower Headrest/Harness Height, To Adjust, Lift the Lower Seat Pad From Front of Car Seat to Expose the Buckle Slots, Turn Buckle Strap Sideways and Slide to Desired Slot, Make Sure Latch Strap Is in Front of Buckle Strap, Replace Seat Pad, Making Sure the Buckle Goes Through the Same Slot in the Seat Pad As in the Plastic Shell, Pull All the Slack Out From Around the Waist, Tighten the Harness By Pulling the Harness Adjustment Strap, Raise the Chest Clip to Child’s Armpit Level, Thread Vehicle’s Shoulder Belt Through Booster Shoulder Belt Guide in the Headrest, Buckle the Vehicle Lap/Shoulder Seat Belt, Remove the Lower Seat Pad to Expose the Latch Strap, Pull Latch Connectors Out of the Belt Path Openings Into the Center of the Car Seat, Slide Entire Latch Strap Along the Red Bar to the Desired Belt Path Openings, Push the Latch Connectors Out Through the Desired Belt Path Openings On Each Side of Car Seat, Move the Headrest to Its Proper Position for Your Child, Lap/Shoulder Seat Belt Installation - Harness Mode, Lap Belt or Shoulder Belt Mounted On Door, How to Lock Your Lap/Shoulder Vehicle Seat Belt, Sliding Latch Plate and Switchable Retractor, Car Seat Graco Seat/Booster Seat Owner's Manual, Car Seat Graco SnugRide Classic Connect 35 Owner's Manual, Car Seat Graco Snugride32 - Quattro Tour Deluxe Travel System User Manual, Car Seat Graco SnugRide Click Connect Base Owner's Manual, Car Seat Graco SnugRide Classic Connect Owner's Manual, Car Seat Graco SnugRide Classic Connect 30 Owner's Manual, Car Seat Graco SNUGRIDE SNUGLOCK Instruction Manual, Car Seat Graco SNUGRIDE I-SIZE Owner's Manual. The Graco® Atlas™ 65 2-in-1 harness booster car seat grows with your child from harness booster (22–65 lb) to high back booster seat (30–100 lb), featuring the … Evaluation of Instructions: The instruction manual cannot be accessed while the child is in the seat. Graco SlimFit: Model Number / Manufacture Date: 1999656 / Nov 16, 2016: Harness Type: Highback: Weight / Height: 30lb - 100lb / 38" - 57" Evaluation of Labels: The shoulder belt portion of the belt path is not labeled. The seat easily transitions from rearward facing infant car seat (birth to 18kg) to forward facing 5-point harness car seat (9-18kg) to highback booster (15-36kg). The Slimfit graco car seat can be installed in rear facing as an infant car seat.